Can't say if it's common, it didn't happen to me. Initially I put a Leupold VX-3L scope on it using Leupold bases/rings. Just replaced that with a...
A little update on my Leupold VX-3L on my X-Bolt: I don't think they're available anymore (not on the Leupold site) - but no matter because while I...
I can't say anything about factory loads - don't have a 7mm in my rack. But I think you probably made a wise decision in going with the X-Bolt over...
I agree with the builds interest and boosts sales theory, I just wish a few more would try making a profit off of the 6.5 Creedmoor. So far I've...
I agree that some appear more oval than round, but not all so it's difficult to say with certainty that the bullets were actually tumbling. But the...
[ATTACH] Actually the holes all appeared round, just widely dispersed. See the picture of some results with them I'll upload. But I went over to a...
John, Not sure I can really answer the 260 vs 6.5CM question other than to say that the 6.5CM was designed for precision shooting after discussions...
Didn't actually measure them - but the orange circle is a Birtchwood Casey target dot and is (I believe as close as I can measure it) that it is...
I'm don't reload them, but have a shooting friend who does. But this page from American Rifleman...
Thanks for the complement. Here's a strategy you might consider - once you decide on a bullet to actually hunt with, get your scope pretty tightly...
Good info, thanks. I got a CZ-455 a while back and went through a lot of shooting of various brands/loads of .22LR before I finally went with the...
You've started looking into one important area of setting up your X-Bolt - what are your shooting conditions going to be like (open areas or heavily...
A few things hold me back from learning that new skill ... first, I live in an apartment complex and it's bad enough that that I've got a few...
I thought I'd follow up with a little comparison based on ballistic calculator results between the (as yet unavailable) Hornady 143 grain ELD-X in...
SHOOTER13, I don't want to hijack this discussion, so I've put up a discussion of my experience with the 6.5 Creedmoor over in the Ammunition forum....
Separate names with a comma.
