most good gunsmiths should have dent removal tools .A long rod is fed into the barrel to the point of the dent ,some i have seen use hydraulics to...
Hi Anatidae I own a B2G engraved by a skilled lady called Rosa.Thank you Gentlemen for the information.The gun resides with me in the UK and has an...
Anatidae ..Thank you very interesting reading your comments.My B25 has 27 1/2" barrels choked 1/4" and 1/4" marked Fabrique Nationale Herstal...
Hey fellas i have B25 with no 44195 S74...........................so would the higher number 46672 date it 1975 as dealer quoted?
IT seems we might open up a whole new discussion about oiling here.Never used a graphite product on a gun my-self just gun oil and grease on the...
I want a 20 bore because of the lighter feel ,for some strange reason i'm getting into the smaller bores been using a 28 bore Perazzi and also shot a...
For some strange reason budzo some folk think loads of oil will make the gun cycle when in truth only a little is needed,but i've seen the wood turn...
Interesting to see a picture of a 16 gauge showing the magazine cut off screw sitting right on the edge of the receiver.Very nice browning by the way.
If i was you i would put the old action spring back for now and see if the grinding stops.As for the cartridge that cycles properley well that can...
Here is a picture of the old stock were the oil has destroyed the wood.
I live in the middle near big reservoirs and can reach the reach the fens in an hour love shooting, fishing and would be happy any where that could...
Thanks for comments fella's many hours of work and the gun could of ended up back in the USA, if the eurocrates had their way and ban ownership of...
So this is my 1970 A5 that came to me for £80,bought for spares as wood was completely ruined by previous owner with a habit of over oiling and...
[IMG] Left the forend a little bit fuller for strength and fitted a spring loaded ball for the end cap
Choose to use English red stock oil applied 8+ coats before wood was fed[IMG] Had a go at checkering from scratch but after a couple of goes let a...
Separate names with a comma.