SA 22 "Browning" scope mount instructions

Discussion in 'Firearm Maintenance, Modification, Safety And Trou' started by DaveinWV, Oct 17, 2019.

  1. DaveinWV

    DaveinWV Copper BB

    I recently bought a 1976 SA 22 and bought the "Browning" scope mount and rings. There were no directions with the mount so I called Browning's tech support. The guy told me to use 18 in/lbs torque on the rear screw that touches the receiver. WRONG !!! I contacted Talley (on the side of the base) and the response is turn the screw in until it touches the receiver.
    I hope this helps someone before they ruin their scope mount.

    regards, Dave

Share This Page