Reassembly assistance

Discussion in 'Browning BL-22 Rifle' started by Gunmedic, Jan 17, 2023.

  1. Gunmedic

    Gunmedic Copper BB

    I'm having trouble reassembling a BL22. I can't get the receiver back into the rifle. I get it about an 8th of the way from being set and it won't go any farther. Anyone have any ideas? Much appreciated. The ejector spring and ejector are installed correctly and the ejector lines up with the groove on the receiver with no issue. I just can't get it slide in all the way
    Last edited: Jan 17, 2023
  2. Rudolph31

    Rudolph31 .30-06

  3. Ranger6

    Ranger6 Administrator Staff Member Administrator Global Moderator Forum Moderator

    Sure wish I had one, so I could find out the answer. These things are pretty pricey. Normally I see them for a $1000 and up.

Share This Page